Apparently, door locks keep locking and unlocking is a regular concern with ultra-modern vehicles that use computerized locking mechanisms. Motors with physical lockout systems, on the other hand, will not have this difficulty because, once physically shut, a car’s physical mechanism always stays closed until the key is turned backward.
Try resetting your GE washer to unlock the lid door. To do this, unplug your machine and wait for one minute. Then, plug it back in. Using your Owner’s Manual, perform the precise steps to activate the internal system reset. You may need to press a specific arrangement of keys to start the reset.

Apply some rubbing alcohol or hand sanitizer on the key and the lock. Heat up the key with a lighter. Warm the keyhole with your breath or a blow dryer. If the key is turning freely but isn’t locking or unlocking the door, the linkages and rods of the locking mechanism may have been disconnected or broken.

L. lewisman007 Discussion starter. 2 posts · Joined 2015. #1 · Aug 22, 2015. Been having an issue with the central locking in my 3 door '06 polo, when using the central locking button on the drivers door both of the doors lock audibly and the bolts are observed to drop down. Soon after however the passenger door unlocks itself and the bolt

Read full answer. The central locking on our 2008 Barina keeps going off repeatedly when unlocking and locking the car. It keeps going for minutes - very noisey - even when driving. You might have a problem with the pcm or the alarm controller take it.to your dealership where purchased and they can assist you!

As Dave mentioned above my model does not have key-less entry, just central locking with the key. Below is a step by step Guide on what I did, Note Problem has "Disappeared" I am not convinced I have solved it. 1. Power cycle the electrical system. (Disconnect and reconnect the battery). . 226 326 325 328 399 309 51 291 330

central locking keeps locking and unlocking